Table of Contents
Advertisement
DI-1162 Remote Access Router
Last Boot Server IP Address – this shows the last boot server
used to download an image file. This is for reference only.
Last IP Address – this shows the last IP address used for the LAN
interface. Again, this is for reference only. The LAN port must
have an IP address in order to access the TFTP server via the LAN
network.
Update Software from Configuration File – Either YES or NO.
If YES, the software update procedure will try to access a
configuration file located at the path defined in the above Boot File
Name. Please ensure that the path and file name of the image file is
listed in the configuration file. If set to NO, the update procedure
will try to find an image file at the Boot File Name path. Please see
Appendix E – Configuration File for more information about
configuration files.
After the parameters are set in the Software Update screen, SAVE the
changes, EXIT, and perform a System Reset or Execute Bootload to
begin the software download process.
After the new runtime software has been downloaded, the router will
automatically start up using the new software with the Software Update
Control setting DISABLED to avoid a downloading loop.
EEPROM Factory Reset
Performing a factory reset erases all settings and tables. All
configuration changes ever made to the router will be deleted. The
router will be set to the factory defaults it was shipped with and will no
longer have an IP address.
126
PROM System Configuration
Advertisement
Table of Contents
