Table of Contents
Advertisement
DI-1162 Remote Access Router
From the Main Menu choose Advanced Functions,
Remote Access Configuration, Remote
Network Profile and press <Enter> in the first empty
field.
Set the Direction to IN, OUT or BOTH.
Enter a Name and Password used to establish Incoming and/or
Outgoing connections (if the remote site uses PAP or CHAP).
Configure the other settings shown in this window.
Change the State to Enable.
Please refer to the Configuration and Management section of
this manual for more detailed information regarding the
settings in this screen.
Position the cursor on the Save option at the bottom of the
screen and press <Enter> to save the new setting.
Choose Exit in the sub-menus to return to the Main Menu.
7.
Define a WAN port for a leased line connection.
There are only three steps that need to be done to configure a
WAN port for using a leased line and they have already been
done. They are numbers 1, 2 and 3; enabling the WAN port in
the Interface Configuration sub-menu, configuring
the Protocol setting to a synchronous mode, and
assigning an IP Address to the WAN port in the Network
Configuration submenu. Remember to save any
submenu screens in which you have made changes.
Choose LOGOFF from the Main Menu
Installation
23
Advertisement
Table of Contents
