Table of Contents
Advertisement
DI-1162 Remote Access Router
3.
Assign an IP address to the WAN port in the Network
Configuration sub-menu of the Main Menu.
Still in Network Configuration, IP
Configuration submenu from Step 2 above, choose IP
Stack Configuration, WAN 1.
Enter a valid IP address for the WAN in the first item. You may
also enter a Netmask if you wish. For more information about IP
Addresses and Subnet masks, please refer to Appendix C – IP
Concepts.
Other items in this screen may also need to be configured such
as the State, Routing and Multicast settings. Please refer to the
appropriate section in the Configuration and Management
chapter of this User Guide for detailed explanations concerning
the nature and use of these items.
Position the cursor on the Save option at the bottom of the
screen and press <Enter> to save the new setting.
Choose Exit in the sub-menus to return to the Main Menu.
Configuring for Dial-in, Dial-out or Leased Line
At this point, you need to decide if the WAN port will be used for
dialing in, dialing out, both or a leased line connection. The settings
you make in next few steps depend on how you wish to use the WAN
port. Remember, only one WAN port should be setup to connect to the
Internet.
4.
Configure the Dial settings in the Advanced Functions
submenu.
Choose Advanced Functions, Remote Access
Configuration, Dial Configuration.
Installation
21
Advertisement
Table of Contents
