Eeprom Factory Reset; Execute Bootload - D-Link DI-206 User Manual

DI-206 ISDN Remote Router
and filename to the configuration file. If you are not using a configuration file,
this must show the path and filename to the software update image file.
Last Boot Server IP Address – This shows the last boot server used to
download an image file. This is for reference only.
Last IP Address – This shows the last IP address used for the LAN interface.
Again, this is for reference only. The LAN port must have an IP address in order
to access the TFTP server via the LAN network.
Update Software from Configuration File – Either Yes or No. If Yes, the
software update procedure will try to access a configuration file located at the
path defined in the above Boot File Name. Please ensure that the path and file
name of the image file is listed in the configuration file. If set to No, the update
procedure will try to find an image file at the Boot File Name path. Please see
Appendix F, "Configuration File" for more information about configuration files.
After the parameters are set in the Software Update screen, SAVE the changes,
EXIT, and perform a System Reset or Execute Bootload to begin the software
download process.
After the new runtime software has been downloaded, the router will automatically
start up using the new software with the Software Update Control setting Disabled
to avoid a downloading loop.

EEPROM Factory Reset

Performing a factory reset erases all settings and tables. All configuration changes
ever made to the router will be deleted. The router will be set to the factory defaults
it was shipped with and will no longer have an IP address.
Please make sure you wish to wipe out all settings and configure the router from
scratch before you perform a factory reset.

Execute Bootload

Choosing this option accepts the changes made in the PROM program and begins
the router's startup sequence.
88