Omron NS-RUNTIME - SOFTWARE User Manual page 153

Messages displayed on the NS-Runtime
Message
Failed to initialize CX-Server.
Check if CX-Server is Installed
and then re-start the system.
Failed to acquire host
information.
Check the communication
setting with the support tool and
transfer the project data again.
Failed to initialize
communication processing.
Exit the application except Run
and re-start the system.
No project data is registered.
Press OK button and download
project data.
Cannot start the project
because the model is not
supported.
Change the project model or
transfer a project which model is
supported.
Supported Model: NS-
Runtime/NSA Series
Error 7:HASP HL Key not found
Cannot open the project data
because it is being edited in CX-
Designer.
Please install the Acrobat(R)
Reader.
Could not startup CX-
Programmer. Please install CX-
Programmer.
Could not startup the SwitchBox
utility. Please install the
SwitchBox utility.
7-3 Error Messages and Countermeasures
Cause
CX-Server is not installed.
Cannot read project data.
(Not downloaded or corrupted.)
Cannot read project data.
(Not downloaded or corrupted.)
Attempted to open a project
that is not supported by the NS-
Runtime/ NSA Series.
Project data is not downloaded.
Two or more projects have
been stored in a project storage
folder (\NS-Runtime's
Installation folder \Runtime).
Attempted to open a project
that is not supported by the NS-
Runtime/ NSA Series.
A USB dongle provided with the
NS-Runtime is not connected.
A project stored in a project
storage folder is being opened
with the CX-Designer.
Displayed a screen with a
document display object on a
computer in which the
Adobe(R) Reader is not
installed.
Failed to start up when
selecting the CX-Programmer
from the system menu.
Failed to start up when
selecting the SwitchBox Utility
from the system menu.
Possible Countermeasure
Install the CX-Server.
Download project data.
Download project data.
Download project data supported
by the NS-Runtime/NSA Series.
Or, convert the project data to a
model that is supported by the
NS-Runtime/NSA Series. Then
download it.
Download project data.
Delete unnecessary project data
from a project storage folder.
Download project data supported
by the NS-Runtime/NSA Series.
Or, convert the project data to a
model that is supported by the
NS-Runtime/NSA Series. Then
download it.
Connect the USB dongle.
Close a project that is opened
with the CX-Designer. Then re-
start the NS-Runtime.
Install the Adobe(R) Reader.
Install the CX-Programmer.
Install the SwitchBox Utility.
7-5