Display - Pioneer Elite VSX-49TX Operating Instructions Manual

Display

All the display information is explained and/or referenced here.
1 2 3 4
SIGNAL L C R
AUTO
L S R
S S
RF
LFE
OVER ATT
DIGITAL
3
AB
SP
ANALOG
TAPE 2
TUNED STEREO MONO
RDS RF ATT
9 10 8 7
1 SIGNAL SELECT indicators
Light to indicate the input signal you selected.
Since there is no indicator light for i.LINK, when
it is selected none of the indicators listed below
will light. When none are lit this indicates i.LINK
is selected
nothing lit – An i.LINK signal is selected.
ANALOG : Lights when an analog signal is
selected.
DIGITAL : Lights when a digital signal is selected.
2RF : Lights when an 2 RF signal is selected.
AUTO : Lights when the receiver is set to select
the input signal automatically.
2 Program Format indicators
For Dolby Digital or DTS sources : These
indicators change according to which channels
are active in the source. When all three LS (left
surround), S (surround) and RS (right surround)
light at the same time it means a source with a
6.1ch playback flag is being used.
L – Left front channel.
C – Center channel.
R – Right front channel.
LS – Left surround channel.
S – Surround channel (mono).
RS – Right surround channel.
LFE – Low frequency effects channel.
3
((( ))) – Lights when LFE signal is input.
4 Analog level indicators
OVER – This lights if the signal is in danger of
distorting for analog source signals. Press
INPUT ATT on the front panel to lower the
signal level.
ATT – Lights when INPUT ATT is used to
reduce the level of the analog source signal.
5 Character display
Shows current mode, status, etc.
Displays & Controls
5
6 Digital format indicators
: Lights when a Dolby Digital
DIGITAL
signal is detected.
: Lights when a DTS signal is detected.
: Lights when an MPEG signal is
MPEG
detected.
: Lights when the HOME THX mode is
selected.
: Lights during Surround EX matrix
processing.
: Lights when a decoding DTS-ES audio.
: Lights during DTS-ES discrete process-
DISC
ing.
: Lights during DTS-ES matrix process-
MTRX
ing.
: Lights during Dolby Pro Logic II
PRO LOGIC
processing.
: Lights during Neo: 6 processing.
Neo :6
: Lights during two-channel
2ch
PLAYBACK
playback.
7 Speaker indicators
Light to indicate the current speaker system, A
and/or B.
8 TAPE 2 indicator
Lights when the TAPE 2 monitor is on.
9 TUNER indicators
MONO : Lights when the tuner is set to receive
FM broadcasts and when selected MPX mode.
STEREO : Lights when a FM stereo broadcast
is received in the auto stereo mode.
TUNED : Lights when a broadcast is received.
10 i.LINK indicator (see p.49, step 3)
Lights when an i.LINK-audio-equipped
component is selected.
6
DIGITAL
DISC MTRX
PRO LOGIC
Neo :6 MPEG
2ch
PLAYBACK
39