Remote Control Of Other Components - Pioneer Elite VSX-49TX Operating Instructions Manual

Remote Control of Other Components

Preset Recall
RECEIVER
ITEM
DVD/LD
DVD
VCR1
/DVR
MAKER
VCR2
PIONEER
VCR3
TV
Preset Recall
RECEIVER
ITEM
DVD
DVD/LD
VCR1 MAKER
/DVR
PIONEER
VCR2
VCR3 NUMBER
1
TV
Preset Recall
RECEIVER
DVD/LD
VCR1
/DVR
VCR2
VCR3
TV
70
[ DVD/LD ]
REMOTE
BACK
SETUP
SELECT MAKER
CD
CD-R/
PIONEER TOSHIBA SHARP TAPE1
TUNER
PANA- SAM-
SONY
SONIC SUNG
VIDEO
VICTOR AKAI DENON
SAT
PAGE
TV
1 / 2
CONTROL
5
6
[ DVD/LD ]
REMOTE
BACK
SETUP
CD
SELECT NUMBER
CD-R/
TAPE1
1 2
TUNER
VIDEO
SAT
SETUP
TV
OK
CONTROL
7
«
8
REMOTE
BACK
SETUP
CD
CD-R/
TAPE1
TUNER
SELECT FUNCTION
VIDEO
SAT
TV
CONTROL
6 Press the number 1 button.
If the component you are trying to control turns on/off,
the setup for this component is complete, but compo-
nents that don't have a standby mode can't respond in
this way. To test if you've set it up properly work
through step 8. Then try using selecting the function
you just setup (for example a CD player) and using the
controls on this remote control. If the component does
not respond, try working through the procedure again
and pressing number 2 instead this time. Continue this
procedure until one of the commands works.
If none of the commands seem to work, try the
learning mode to program the component into the
remote control. This is explained on the following
page.
To go back a screen
press the BACK button.
To exit the process without inputting the com-
mands
press the BACK button repeatedly.
7 Press the SETUP OK button and the
screen returns to SELECT FUNCTION
so you can program another
component into the remote control.
Naturally it's easiest and most logical to assign the
button that has the same name as the component you
are setting up (for example, choose the DVD/LD button
for your DVD player).
You may find you have components which do not
correspond to the name on any MULTI CONTROL
button (for example a cable TV tuner) or you have two
components where only one button is provided (for
example, CD-R/TAPE 1). In this case, use step 3 to
assign any available MULTI CONTROL button to the
component you want to remote control.
For example, you may have both a CD-R and a tape
deck in your system but only one video deck. It would
make sense to assign the CD-R/TAPE 1 MULTI
CONTROL button to the CD-R and the VCR 2 MULTI
CONTROL button to your tape deck. To do this choose
VCR 2 in step 3 when you want to set up the tape
deck. Then choose TAPE in step 4 and proceed as
above. The only practical difference in this method is
that you have to remember the VCR 2 MULTI CON-
TROL button is actually your tape deck.
In this case, you would need to hook up your tape
deck to the input jacks marked VCR 2 on the back of
the receiver.
This method should help you customize the remote
control for your system and let you control all of your
components with the remote control for the VSX-49TX.
8 Repeat the process from step 2 for
all of your components.
9 Press the BACK button repeatedly to
leave the REMOTE SETUP mode.