Thx Audio Setup; Thx Ultra2 Subwoofer Setup - Pioneer Elite VSX-49TX Operating Instructions Manual

Advanced Setup

THX Audio Setup

THX Ultra2 Subwoofer Setup

If you have a high-precision speaker that outputs very low frequencies, the sound may have too much boom
because of the resonant frequencies in the room where your subwoofer is setup. If you have this problem use
the THX Ultra2 Subwoofer Setup to adjust the low end sounds.
1
Receiver
RECEIVER
TONE
DVD/LD
VCR1
DISPLAY
/DVR
DIMMER
VCR2
STATUS
VCR3
3
SYSTEM
TV SETUP
5˜∞˜2˜3˜ENTER buttons
4
System Setup
[ Auto Surround Setup ]
[1. Input Assign]
[2. Surround Setup]
[3. Expert Setup]
[4. THX Audio
[Exit]
5 4.THX Audio Setup
[ 1.Ultra2 SW Setup
[ 2.SB SP Position ]
[Return]
6
4.1. Ultra2 SW Setup
THX Ultra2 SW?
Boundary Gain
Compensation
[Return]
7,8
4.1. Ultra2 SW Setup
THX Ultra2 SW?
Boundary Gain
Compensation
[Return]
• If you select YES the BASS PEAK
memo
LEVEL limiter (see p.99) will be can-
celled.
• See the THX section in Techno Tid-
104
bits (p.108) for more information on
Boundary Gain Compensation.
2
MAIN SUB REMOTE
SETUP
BASS/ CD
ATREBLE
CD-R/
TAPE1
EFFECT/
CH SEL.
VIDEO TUNER
SELECT
VIDEO
SPEAKER INPUT
LOUDNESS
A/B ATT.
SAT
TAPE 2 SIGNAL
TV
MONITOR
SELECT
CONTROL
STANDBY/ON
ENTER
Setup]
]
[ YES ]
[OFF]
[ YES ]
[ OFF ]
1 Turn on the receiver and your TV,
press the RECEIVER on the remote
control.
Make sure your TV is set to the receiver.
2 Press the SUB button on the receiver
screen.
3 Press the SYSTEM SETUP button.
The menu possibilities appear on your TV.
4 Use the 5∞ buttons to select THX
AUDIO SETUP. Press ENTER.
5 Use the 5∞ buttons to select
ULTRA2 SW SETUP. Press ENTER.
6 If your subwoofer is THX Ultra2
certified, select YES. Use the 2 3
buttons and then press ∞.
If your subwoofer isn't THX Ultra2 certified, but you
still want to switch the boundary gain compensation to
ON, select YES but the results may not be satisfactory.
7 Use the 2 3 buttons to select ON or
OFF.
8 Use ∞ to select RETURN then press
ENTER.
9 If you want to continue THX AUDIO
SETUP use the 5∞ buttons to select
the next setup and press ENTER.
Go on to the next page.
10 If you want to finish THX AUDIO
SETUP use the 5∞ buttons to select
RETURN and press ENTER. Then use
the 5∞ buttons to select EXIT and
press ENTER.