Dpmr Operation; Receiving A Call - Icom IC-F29DR3 Operating Instructions Manual

6
Section
The IC-F29DR3 can be used in both digital and analog modes.
In the digital mode, digital call, RX Status, Break-in request, and Alert-Ring functions are supported.

Receiving a call

D Receiving a call
When a call is received:
• Mute is released.
• The Status indicator lights green.
1. Hold down [PTT] to speak.
2. Release [PTT] to receive.
D Receiving a Status call
When receiving a Status call, the ringer sounds and the Status indicator blinks, depending on the presetting.
Ask your dealer for details.
NOTE: You cannot send a Status call with the IC-F29DR3.
D Receiving a Break-in request call
When a Break-in call is received:
• The Status indicator lights green.
• The ringer sounds.
L Push any key to stop sounding the ringer and blinking the Status indicator.
TIP: What is a Break-in call?
The Break-in request call announces to the other stations on the channel that the user wants to break into the
current communication in the group.
The transceiver waits for the current communication to end, and then sends the call.
Example: Station A, B, and C communicate using the same Common ID.
Station A
After Station A releases [PTT] (transmission is finished.)
Break!
Station A

dPMR OPERATION

Station B
Push
[Break]
Station C
Wait
Break!
Station B
Station C
FELLECS-TECH | inbox@fellecs-tech.com | www.fellecs-tech.com
Station C pushes [Break] to
transmit the Break-in Request
call while Station A is
transmitting.
Station A and B receive the
Break-in Request signal.
25