Setting The Squelch Level - Icom IC-F29DR3 Operating Instructions Manual

5
SETTINGS

Setting the squelch level

You can adjust the squelch level. The squelch circuit
mutes the received audio or noise signal, depending
on the signal strength.
NOTE: Turn ON the Beep function (p. 16) before
you start setting the squelch level.
1. Rotate [VOL] to turn OFF the transceiver.
2. Set [Rotary Selector] to any channel other than
Channel 16.
3. While holding down [Upper], rotate [VOL] to turn
ON the transceiver and enter the Squelch Level
Adjustment mode.
• An opening beep sounds and the selected channel
number will be announced.
4. Push [Upper] to increase the squelch level (tight
squelch), or push [Lower] to decrease the squelch
level (loose squelch).
• A beep sounds after pushing [Upper] or [Lower].
An error beep sounds if you try to exceed the
adjustable range.
 The adjustable range is 0 (loose squelch) to 9 (tight
squelch).
5. Rotate [VOL] to turn OFF the transceiver and exit
the Squelch Level Adjustment mode.
FELLECS-TECH | inbox@fellecs-tech.com | www.fellecs-tech.com
[Rotary Selector]
[Upper]
[Lower]
21
[VOL]