Safety and installation
For the latest full version of this document, which includes both the Safety and Installation section
and the Operating sections for UniSAB 4, use the following QR code or
docs.jci.com/Sabroe/UniSAB
4:
Figure 1: QR code
Preface
This product is engineered and supported by:
Johnson Controls Denmark ApS
Christian X´s Vej 201
8270 Højbjerg, Denmark
Phone +45 8736 7000
www.sabroe.com
This manual must not be copied without the written permission of Johnson Controls Denmark, and
the contents must not be imparted to any third parties nor be used for any unauthorized purposes.
Contravention will be prosecuted.
Read the manual carefully so that you fully understand the UniSAB 4 control system, and know
how to operate it correctly. Damage occurring as a result of incorrect operation is not covered by
Johnson Controls Denmark guarantee.
If it is discovered that supervisor level access has been used to set a value that is critical for safe
compressor operation, foe example outside the specified limits, which can cause irregular or
incorrect operation or, in worst case, breakdown, it must be anticipated that Johnson Controls
Denmark is considered entitled to reduce its warranty obligations. Johnson Controls Denmark
further accepts no liability of any kind for damage to the compressor unit and plant parts caused
by torsional oscillation, or the like, which is attributable to built-in VSD solutions initiated by the
customer after delivery.
Note the version number of this manual. The version number is printed on the preceding page, and
it is important that this number is identical to the UniSAB 4 version number shown in the picture
Service/Diagnosis/Software/Software version. Never use a manual with a lower version number
than your UniSAB 4 software.
UniSAB 4 Safety, Installation, and Operating Guide
5
Need help?
Do you have a question about the SABROE UniSAB 4 and is the answer not in the manual?