Call Channel - Icom IC-W2A Instruction Manual

ae!
mmm S = 3s CALL:« CHANNEL
@ Calling up the call channel
A one-touch access call channel is provided on each band
and is separate from the memory channels. Use the call
channel for your most-often-used frequency.
[uan]
6.89 440.00
38
@ Programming a call channel
Call channels can be programmed with not only an operat-
ing frequency but also a duplex function and independent off-
set frequency.
nn it
46.88 b Hate
= [ua
6.00 438d
3G c 36
1) Push [V MAIN] or [U MAIN] to select the desired band.
2) Push [(@) CALL] to display the call channel.
3) Push [@) CALL] again to return to the previous mode.
* [(@ V/M] can also return to the previous mode.
@ Transferring a call channel
1) Push [@) CALL] to call up the call channel.
2) While pushing [F], push and hole (@) MP V] until the tran-
sceiver emits 3 beeps.
* VFO mode is automatically selected.
1) Push [V MAIN] or [U MAIN] to select the desired band.
2) Push [@ V/M] to select VFO mode; then, set the desired
frequency to be programmed into the call channel.
* Duplex information can also be programmed.
3) Push [() CALL] to call up the call channel.
4) While pushing [F], push and hold [@) MW] until the tran-
sceiver emits 3 beeps.
* Programming is completed and VFO mode is automatically
selected.