Aquaquake Water Draining Function; Setting The Call Channel - Icom IC-M25 Instruction Manual

AquaQuake Water Draining
function
Water in the speaker grill may muffle the sound coming
from the speaker. The AquaQuake Water Draining function
removes water from the speaker grill, by vibrating the
speaker.
 Hold down both [SCAN] and [Hi/Lo] for 1 second.
• A low vibration tone sounds for 10 seconds to drain water,
regardless of the volume level setting.
• This function also stops when a key is pushed.
NOTE: This function does not activate when an external
speaker microphone is connected.
FELLECS-TECH | inbox@fellecs-tech.com | www.fellecs-tech.com

Setting the Call channel

You can recall the most often-used channel with a single
operation, by setting the channel as the Call channel.
The Call channel can be set in each channel group.
1 Hold down [U/I/C] (CH/WX) for 1 second to change the
channel group. Repeat to go to the desired group.
2 Hold down [16/C] for 1 second to recall the current Call
channel in the selected group.
• "CALL" and the Call channel number appear.
3 Hold down [16/C] again for 3 seconds (until a long beep
changes to 2 short beeps) to enter the Call channel
setting mode.
• The channel number starts blinking.
4 Push [▲] or [▼] to select the new Call channel.
5 Push [16/C] to set the displayed channel.
• 2 short beeps sound.
• The channel number stops blinking.
BASIC OPERATION
4
4
13