Icom IC-W2A Instruction Manual page 42

14 CLOCK AND TIMER OPERATION
@ Power-off timer
The transceiver has a power-off timer separate from the auto-
off function to turn power OFF at the preset time.
© Setting power-off time
1) Enter CLOCK mode:
- Push [V MAIN] to select the VHF band.
- Push [©) CLOCK] to access CLOCK mode.
2) Select the power-off display:
- Push [7/SCAN] to select the display as shown above.
3) Recall the previously set time:
- While pushing [F], push [@ MASK].
4) Set the power-off time:
- While pushing [F], push [@) SET] to set the transceiver in the
time-setting condition.
- Rotate the main dial to set the hour.
- Push [A/SCAN] or [V/SCAN], then rotate the main dial to set
the minute.
- Push [@ ENT] to enter the time.
5) Exit CLOCK mode:
- Push [# CLR].
* Power-off timer operation
1. ' ®" appears on the display when the power-off timer is
activated.
2. The power-off timer will turn power OFF at the set time.
*5 beeps sound when the preset time arrives.
3. The preset time will be masked when the transceiver is
turned OFF by the power-off timer.
* The programmed time is retained even after the transceiver is
turned OFF by the [POWER] switch at the preset time.
4. To deactivate the timer function, set the power-off time to
be masked. Repeat steps 1~3 in ''Setting power-off time"
to select the masked display.