Icom IC-W2A Instruction Manual page 11

FUNCTION
Selects VFO or MEMORY mode. (p. 24)
Used only for numeral input.
Turns ON the display lighting for 5 sec.
(p. 34)
Calls up the call channel. (p. 23)
Selects the tuning step. Use the switch
together with the main dial. (p. 17)
Used only for numeral input.
Sets the selected memory channel as a skip
channel. (p. 31)
Used only for numeral input.
Selects high or low output power. (p. 4)
Clears the input digit before entry.
Exits the SET and CLOCK modes.
(pgs. 16, 22)
Enters CLOCK mode. (p. 35)
PANEL DESCRIPTION 2
WHILE PUSHING [F] AFTER PUSHING [ENT]
Writes the VFO contents into the memory chan-
nel or call channel when pushed and held.
(pgs. 23, 25)
No secondary function.
Turns ON the display lighting continuously.
(p. 34)
Transfers the contents in the selected memory
or call channel into the VFO. (p. 26)
Selects the dial select step from among 100 kHz,
1 MHz or memory channel changing. (p. 17) | Inputs digits for frequency
Turns the PTT lock function ON and OFF. setting, M18}
(p. 18)
Hides and displays the selected memory chan-
nel. Memory channel 1 cannot be hidden.
(p. 26)
Enters SET mode. (p. 22)
Selects low output power in 3 levels. Use this
function together with the main dial. (p. 18)
Turns the beep function ON and OFF.
(p. 34)
Turns the auto off function ON and OFF.
(p. 35)
Sets the keyboard for numeral use. (p. 16)
Turns the lock function ON and OFF. (p. 15)
———————
tl