14, Clock And Timer Operation - Icom IC-W2A Instruction Manual

@ Clock operation
¢ Setting time
Only the VHF band can be used for clock setting.
1) Enter CLOCK mode:
- Push [V MAIN] to select the VHF band.
- Push [©) CLOCK] to access CLOCK mode.
2) Set the time:
- While pushing [F], push [(@ SET] to set the transceiver in the
time setting condition.
- Rotate the main dial to set the hour.
- Push [A/SCAN] or [V/SCAN], then rotate the main dial to set
the minute.
- When a wrong time is set, push [&) CLR] and begin this proce-
dure again.
~ Push [@ ENT] to enter the time.
3) Exit CLOCK mode:
- Push [® CLR].
[EXAMPLE]: Set the time for 13:45.
V MAIN
CLOCK AND TIMER OPERATION 14
* Clock indication
1. To display the clock, push [©) CLOCK].
* On both the VHF and UHF band displays, the clock can be in-
dicated.
2. To make the clock disappear, push [%&) CLR].
3. Receiving are possible even when the clock display is
indicated.
TIME ERROR: +1 min./week
NOTE: CPU resetting clears the clock time. Set the
time again, if desired.