Section 6
Updating the Firmware
■ Setting the connection port
If you have failed to start Warp Engine ZS, a message will appear, followed by the dia-
log box shown on the right.
1.
Select [Settings]-[Control Panel] from the [Start] menu of the personal com-
puter, and then double-click [System].
The [System Properties] dialog box will appear.
2.
Open the [Hardware] tab and click [Device Manager].
The [Device Manager] dialog box will appear.
3.
Open [Ports (COM&LPT)] and check the COM number in "OMRON Smart
Sensor USB COM Drivers (WDM) (COMxx)".
"COMxx" indicates the connection port of the Amplifier Unit.
4.
Select the connection port of the Amplifier Unit from [COM Port], and click
the [Set] button.
Warp Engine ZS will start.
ZFV-C
144
User's Manual