Installing The License Key Driver - Omron WS02-LCTC1-E - V2.60 REV 12-2003 Manual

Installation

2-1-4 Installing the License Key Driver

1, 2, 3...
32
System Info from the Set up Menu and then open CRT Builder. After saving
once, set the main system settings.
This section describes the License key driver installation procedure. You can
also install the License key driver before installing CX-Process Monitor.
1. Connect the WS02-LCTK1-EL01 License Key to your computer printer port.
2. Using Explorer, select Setup.exe from the SystemDriver folder on the CD-
ROM.
3. After installation is completed, be sure to restart Windows NT/2000.
Note If your computer is a Fujitsu FM/V, after installing the License Key
Driver, you must cycle the power supply to the computer, and then
restart Windows NT/2000.
Note 1. When using the CX-Process Monitor, make sure that the the
WS02-LCTK1-EL01 License Key is always connected to the printer port. If
the WS02-LCTK1-EL01 License Key is not connected to the computer print-
er port, or even if it is connected, if the License key driver is not installed, you
cannot use CX-Process Monitor.
2. Even if the License key driver is installed, nothing will be displayed on the
screen. To check that the driver is installed correctly, select Settings, and
then Control Panel, and then Multimedia. Check using the Multimedia
Properties dialog box, by selecting Other Multimedia Devices, and then
displaying Sentinel for i386 Systems.
3. To uninstall the License key driver, in the Multimedia Properties dialog box,
select Sentinel for i386 Systems, and then select the Remove Button.
WS02-LCTK1-EL01
Section 2-1