Omron WS02-LCTC1-E - V2.60 REV 12-2003 Manual page 172

FinsGateway Settings when Connected Using Controller Link
3. Click the Data Link Table Settings Button.
4. Click the Local Node Button, and then click the Next Button.
Enter fields (1) to (5) as shown above. The procedure is shown below.
Before making the settings, check that nothing is entered in column (5). If there is an entry in the
column, make sure to click the Delete Button and delete everything.
1) Set the Area 1 type to DM. Set the Start Word to 20.
2) Set the Area 2 type to CIO. Area 2 is not used in monitoring, but make sure that the settings for
Area 1 and Area 2 are different.
3) Enter the node to be refreshed.
Set the number of words in Area 1 to 536, and set the Offset to 0. (Set the number of words to 636
when using a Terminal to All Nodes function block.)
Set the number of words in Area 2 to 0, and set the Offset to 0.
4) Click the Add Button.
5) Check that in Node 1's Area 1, the number of words is set to 536 and the Offset is set to 0.
164
1)
4)
3)
Appendix B
2)
5)