Outline; Procedure To Start Monitoring - Omron WS02-LCTC1-E - V2.60 REV 12-2003 Manual

Procedure to Start Monitoring

3-1

Outline

1, 2, 3...
3-2

Procedure to Start Monitoring

1, 2, 3...
38
This section explains the functions and operations for each screen primarily for
those people who will operate CX-Process Monitor. The explanations assume
that CX-Process Tool settings and screen configuration for the CX-Process
Monitor have already been completed.
Refer to Section 4 Screen Configuration for how to configure CX-Process Moni-
tor screens. Also, refer to CX-Process Tool Operation Manual (W372) for CX-
Process Tool settings.
CX-Process Monitor screen configuration is already completed, monitor the
Loop Control Unit mainly by performing the following operations.
1. Start CX-Process Monitor (refer to 3-3 Starting and Stopping CX-Process
Monitor).
2. In the Mode Selection Dialog Box, click the Operator Button to display the
Overview Screen (refer to 3-3 Starting and Stopping CX-Process Monitor).
3. From the Overview Screen, move to each of the following screens.
• Control Screen (see 3-6 Control Screens)
• Tuning Screen (see 3-7 Tuning Screens)
• Trend Screen (see 3-8 Trend Screens)
• Graphic Screen (see 3-9 Graphic Screens)
• Annunciator Screen (see 3-10 Annunciator Screens)
• Operation Guide Message Screen (see 3-11 Operation Guide Message
Screens)
• Alarm Log Screen (see 3-12 Alarm Log Screens)
• Operation Log Screen (see 3-13 Operation Log Screens)
• System Monitor Screen (see 3-14 System Monitor Screens)
• System Monitor Log Screen (see 3-15 System Monitor Log Screens)
Note If the WS02-LCTK1-JL01 License key is not connected to the computer printer
port, or even if it is connected, if the License key driver is not installed, you can-
not use the following monitor screens or configuration screens. (If you try to
switch to the following screens, an error message will be displayed.)
Monitor Screens
Item
User-defined screens
System screens y
The procedure until starting monitoring is as follows:
1. Select Start, Programs, Omron, CX-Process Monitor, CX-Process Mon-
itor.
2. In the Main Window, click the Start Button.
3. In the Mode Selection Dialog Box, click the Operator Button.
4. In the Overview Screen, select Control Screen, Trend Screen, etc. as re-
quired.
Note Steps 2 and 3 will not be required and a specified screen will be displayed if auto-
starting is enabled. Autostarting can be enabled by clicking the System Info.
Screen
Trend screen
Graphic screen
Operation Guide screen
Alarm Log screen
Operation Log screen
System Monitor Log screen
Section 3-2