Omron WS02-LCTC1-E - V2.60 REV 12-2003 Manual page 171

FinsGateway Settings when Connected Using Controller Link
Example 1: Number of Other Nodes is 1 (There is Only 1 PLC)
Controller Link Unit
In the above configuration, one PLC is connected to the network. The Controller Link Unit's node address is set to 1
using the rotary switch on the front of the Unit.
Creating the Local Node's Data Link Table
1, 2, 3... 1. Select FinsGateway, and then select FinsGateway Settings, and then select Controller Link
Properties.
2. Click the Data Link. The following dialog box will be displayed.
Loop Control Unit
Controller Link
Appendix B
Controller Link Support
Board
163