Table of Contents
Advertisement
Wiring the Control Circuits
Only basic insulation is provided for the control circuit terminals.
Additional insulation may be necessary in the end product.
• Control Circuit Terminals (of the buld-in inverter unit)
Pass the cable through the wiring hole to connect it. Always mount
the cover in its original position.
SW1 can be changed according to sequence input signal (S1 to S7)
polarity.
0 V common: NPN side (factory setting)
+24 V common: PNP side
Refer to pages 218 and 219 for SW1.
Refer to pages 120 and 136 for SW2.
Wiring the Control Circuit Terminals
Insert the wire into the lower part of the terminal block and connect
it tightly with a screwdriver.
34
Contact Output
Screwdriver Blade Width
0.4 mm max
(0.016 in.)
2.5 mm max
(0.098 in.)
Advertisement
Table of Contents
