Installation On The Wheelchair - Permobil ROHO AGILITY Back Support Direct Mount Hardware Operation Manual

Installation On the Wheelchair

Warnings:
- DO NOT perform any tasks without first reading and understanding all of the safety information and provided instructions.
- DO NOT remove or install the AGILITY while the individual is seated in the wheelchair.
- DROPPING, PINCHING, CRUSHING RISK: The AGILITY with Direct Mount Hardware is heavy. To avoid injury, hold securely and use extreme caution when
installing, adjusting, removing or otherwise handling the AGILITY with Direct Mount Hardware. Ask for assistance if needed.
- After installation and adjustment is complete, and before the individual transfers into the wheelchair, make sure all hardware is securely tightened. Refer to the
recommended torque specifications. If the hardware is not securely tightened, the AGILITY may shift up or down during operation, which could result in injury to
the user or may reduce or eliminate the product's benefits.
To prepare for installation:
STOP: If the Direct Mount Hardware is NOT installed on the AGILITY, stop here and refer to
"Separately Purchased AGILITY - Installation of Direct Mount Hardware" in this manual.
1. Remove any existing wheelchair backrests:
Follow the Permobil Corpus instructions to remove the backrest cushion and
plates, as shown below.
a. Remove the backrest cushion, which is attached with hook and loop
fastener strips.
b. Remove the upper backrest
plate: Move the locking
mechanism catch outwards,
and then pull the section
straight up.
b. Remove the lower backrest
plate: Remove the thumb
screw (or "knob"), and then
detach the lower backrest plate
by sliding it up and then away
from the four pins.
ROHO AGILITY Back Support Direct Mount Hardware Operation Manual
2. Check the Direct Mount Hardware Position: The Direct Mount Hardware
5
MUST be in the lowest position on the AGILITY in order to attach it to the
wheelchair. If you need to adjust the position of the Direct Mount Hardware:
a. Loosen the nylon-insert lock
nuts on the AGILITY.
b. Make sure the bottom handle of the cover is
attached to the cover with the hook and loop
fastener strip (or it can be tucked into the lower flap).
Make sure the bottom handle of the cover does not
hang down.
c. Slide down the Direct Mount
Hardware on the AGILITY as
far as it will go.
d. Use the wrench to tighten all
four lock nuts until snug.