Troubleshooting; Maintenance, Cleaning And Disinfecting - Permobil ROHO AGILITY Back Support Direct Mount Hardware Operation Manual

Troubleshooting

For additional assistance, contact a Permobil-authorized technician, distributor, or Customer Support.
Not able to slide the Direct Mount
Hardware all the way down on the
AGILITY back shell.
Not able to access the cap screw when
installing AGILITY on the wheelchair.
Not able to tighten the cap screw
while installing the AGILITY on the
wheelchair.
Not able to attach the Direct
Mount Hardware to the pins on the
wheelchair.
Not able to access a bolt when
installing the Direct Mount Hardware
on the AGILITY.
A component is damaged.

Maintenance, Cleaning and Disinfecting

Warning: DO NOT continue to use the product if any part is broken, cannot be tightened, or is not functioning properly. Periodically, the product should be
thoroughly inspected by a Permobil-authorized technician.
Check daily to confirm the tightness of screws and hardware. Re-tighten loose screws, following the instructions in this manual. Check components daily for wear
or damage and replace if necessary.
Warnings:
- Cleaning and disinfecting are separate processes. Cleaning must precede
disinfection. Before use by a different individual: clean, disinfect, and check
product for proper functioning.
- Clean the product regulary and when it becomes soiled.
- Follow safety guidelines on the chemical containers.
Component: Back shell, Direct Mount Hardware
To Clean: Hand wash with a sponge, using soap and water. Rinse with clean water. Wipe dry with a clean cloth and then allow to air dry
completely.
To Disinfect: Wipe gently with a cloth dampened with a household disinfectant. Rinse with clean water. Wipe dry with a clean cloth and then
allow to air dry completely.
Recommendation: When washing by hand, use room-temperature water.
Care Symbols
Wipe with damp cloth.
ROHO AGILITY Back Support Direct Mount Hardware Operation Manual
Make sure the cover handle is either attached to the hook and loop fastener strip or tucked into the lower cover flap
before sliding the Direct Mount Hardware all the way down.
Make sure the Direct Mount Hardware is in the lowest possible position on the AGILITY back shell.
Make sure that all four keyholes on the Direct Mount Hardware are engaged with all four pins on the wheelchair.
Warning: Tightening the cap screw does NOT necessarily mean that the Direct Mount Hardware is securely
installed. The cap screw can be tightened while the pins are NOT fully engaged in the keyholes. After tightening the cap
screw, test for a secure installation by pushing forward on the AGILITY (toward the front of the wheelchair). See the
instructions for installing the Direct Mount Hardware on the wheelchair.
Make sure the wheelchair backrest cushion and backrest plate(s) are removed. Refer to the wheelchair manufacturer's
instructions.
Make sure the Direct Mount Hardware is not turned upside down. See the images in the installation instructions.
If a bolt is not visible, reach your hand between the cover and the back shell and push the bolt until it protrudes through
the slot. Attach the washer and the lock nut.
Contact Customer Support for a replacement.
Dry flat.
Cautions:
- DO NOT use abrasives such as steel wool or scouring pads on the product.
- DO NOT use cleaning products containing petroleum or organic solvents [i.e.
acetone, toluene, Methyl Ethyl Ketone (MEK), naphtha, dry cleaning fluids,
adhesive removers] on the product.
12
Hand wash.