Separately-Purchased Agility: Installation Of Direct Mount Hardware - Permobil ROHO AGILITY Back Support Direct Mount Hardware Operation Manual

Separately-Purchased AGILITY: Installation of Direct Mount Hardware

Warnings:
- DO NOT perform any tasks without first reading and understanding all of the safety information and provided instructions.
- DO NOT remove or install the AGILITY while the individual is seated in the wheelchair.
Except for the sliding height adjustment bar, none of the hardware provided with a separately-purchased
AGILITY is intended for use with Direct Mount Hardware. Follow the instructions carefully. Using the wrong
components may result in damage to the product and/or injury to the user.
1. Remove the AGILITY Cover.
2. Remove all AGILITY hardware.
Set aside everything except the
sliding height adjustment bar:
a. Remove and DO NOT reuse.
Store in a safe location.
b. Remove and reuse the sliding height adjustment
bar (x2) with the Direct Mount Hardware. See
below.
3. Attach the Direct Mount Hardware components and the sliding height
adjustment bar:
a. Place the 20mm Direct Mount Hardware bolts in
the sliding height adjustment bar, leaving three
open spaces between the bolts.
b. On the back side of the AGILITY, place the Direct
Mount Hardware nylon washers and star washers
on the bolts.
c. Reattach the AGILITY Cover. Refer to the
instructions provided with the ROHO AGILITY Back
Support.
d. Place the Direct Mount Hardware onto the AGILITY
back shell and in the lowest position. Make sure the
AGILITY Cover handle does not hang down. A bolt
should protrude through each opening in the Direct
Mount Hardware.
e. On both sides, attach the Direct Mount Hardware
washers and nylon-insert lock nuts.
4. See the instructions in this manual for installation on the wheelchair.
ROHO AGILITY Back Support Direct Mount Hardware Operation Manual
A B C D
A
AGILITY lock nut (x4)
B
AGILITY adjustment plate (x2)
C
AGILITY star washer (x4)
D
25mm AGILITY bolt (x4)
2a
3a
3b
8
2b
3c
3d
3e