Table of Contents
Advertisement
Time to reassemble the sensor. First screw in the ground electrode by hand and snug it down
a bit with the wrench. Do not overtighten. Actually, the main purpose of the wrenches is to
take the sensor apart so don't overtighten and strip the threads when reassembling.
Then screw on the outer shell. Again, be easy with the wrench! Don't ask us for torque
targets; you're not going to run out and buy a tiny custom torque wrench and it's not critical.
Just be easy and don't strip the treads.
54
Advertisement
Table of Contents
Need help?
Do you have a question about the pmCAN Module and is the answer not in the manual?
Questions and answers