Table of Contents
Advertisement
4. Make sure the O-ring is on the eurofast connector.
5. Slide the PCB back into the enclosure and reattach the four screws on the front of the
module.
6. Put the washer and nut on the eurofast connector and tighten.
7. Connect the module to a power supply and a PC (via a CAN communication adapter)
using the cabling shown. A sensor does not have to be connected to the module.
Note that only one module is connected and a display head is not involved.
28
P/N 11-02, DC Power Cable,
DB9F, Banana Plugs (shown), or
P/N 11-01, DC Power Cable,
DB9F, Spades
Termination Resistor
Figure A1: Module prepared for Reprogramming
To CAN adapter
on PC
To power
Advertisement
Table of Contents
Need help?
Do you have a question about the pmCAN Module and is the answer not in the manual?
Questions and answers