Table of Contents
Advertisement
1V4V (dashCAN2 and dashCAN+ only)
"1V4V" commands the analog outputs to go to 1V then 4V. This is used to verify that the
data acquisition system reading the analog outputs is correctly reading them.
LOCK
"LOCK" locks the MOd, RATE, AOUT, dISP, and LEdS setup. This stops unauthorized
modification of the display. Refer to Appendix E for more information.
23
Advertisement
Table of Contents
Need help?
Do you have a question about the pmCAN Module and is the answer not in the manual?
Questions and answers