Table of Contents
Advertisement
8. Start the Configuration Tool (software). Click on the "Module" tab.
Select the CAN adapter being used. Then start the communication.
9. Click on the "Stand-Alone" button. Wait for the "Done" Message.
Stop communication and exit program. The module is in Stand-Alone Mode.
To convert a module from Stand-Alone Mode to EIB Mode
1. Connect the module to the Configuration Tool and click on the "EIB" button.
2. Open the module and put the jumper on just one pin (either one).
3. Close up the module.
29
Advertisement
Table of Contents
Need help?
Do you have a question about the pmCAN Module and is the answer not in the manual?
Questions and answers