Maintenance Concept And Eligibility - AUTO GYRO Cavalon Maintenance Manual

Maintenance Concept and Eligibility

The maintenance concept of the Cavalon gyroplane is structured into 3 qualification levels:
▪
Basic Operator (OPR) Maintenance / Pilot Checks and Servicing
Line (LNE) Maintenance – Inspection and general maintenance tasks, inspection of Critical
▪
Parts (CP
▪
Specialized (SPC) Level Tasks (Major Modification, Repair & Overhaul, Special Topics)
The respective maintenance level for each maintenance task is printed in right hand position in the
header line on each Job Card as three-letter code for quick reference (see red circle in example below)
and repeated under 'GENERAL, REFERENCES AND REQUIREMENTS'.
Maintenance tasks may be carried out solely by persons or organizations fulfilling the requirements for
personal qualification, infrastructure and required equipment, and only in strict compliance with the
documentation and manuals listed in below table. Examples are provided for better illustration:
Level Qualification
OPR Licensed Pilot or
trained/briefed person
LNE AutoGyro maintenance course
(and/or organization approval)
SPC AutoGyro special courses and
organization approval
AMM-CV-915iS/916iS-EN-
A-2023-12
Aircraft
Maintenance Manual
Documentation
Pilot's Operating Handbook
and Job Cards marked 'OPR'
Aircraft Maintenance Manual
(AMM) Job Cards 'LNE'
Aircraft Maintenance Manual
(AMM) Job Cards 'SPC' and
appropriate device
manufacturer instructions
Part A – Introduction and
Declarations
AutoGyro
Cavalon 915 iS / 916 iS
Example
Check and replenish
engine coolant
All tasks to perform a
100 hrs inspection
Adjust / replace rotor
head, flight controls
Main frame overhaul,
major modification and
repair
Page 7 of 15