Interfaces And Communication; Display And Buttons - Eaton 9A UPS Manual

4

Interfaces and communication

4.1 Display and Buttons

The screen provides useful information about the UPS input, output, load, setting and fault
information.
The following table shows the description of LCD button:
Switch
ON-Button
OFF-Button
Select-Button
Enter-Button
Hz
Vac
INPUT BATTERY
+
Function
Turn on UPS system: By pressing the "ON" button, the UPS system is turned on.
Deactivate acoustic alarm: By pressing this button an acoustic alarm can be deactivated in the
battery mode. By short touch this Button all acoustic alarms can be deactivated in all mode.
Do the battery test: By pressing this Button the UPS can do the battery test in the Line mode
or ECO mode or Converter mode.
When mains power is normal, the UPS system switches to No output or Bypass mode by
pressing "OFF" button , and the inverter is off. At this moment, if Bypass is enabled, then
the output sockets are supplied with voltage via the bypass if the mains power is available.
Deactivate acoustic alarm: By pressing this button an acoustic alarm can be deactivated in
the bypass mode.
Release the UPS from fault mode and EPO status.
The output voltage, frequency, Bypass disable/enable and operating mode in No output or
Bypass mode, The number of EBM in all mode, could be selected by pressing Select-Button,
and confirmed by pressing Enter-Button.
Hz
Vac
OUTPUT LOAD
17
9A UPS 1-3K