15.11 Compressor Disassembly; 15.12 Removing The Cpu Board - Saeco MAGIC M2 Technical Manual

English
Slightly rotate counterclockwise the solenoid pilot valve unit and pull it out.
Disconnect it from the electrical power supply in the event of replacement.

15.11 Compressor disassembly

The following tools are necessary to remove this component:
Torx screwdriver T10
Disassemble the external covers as described above, until disassembly of the upper
cover, to access the component to be replaced.
Disconnect the silicone pipe.
94
Remove the fastening band. Remove the compressor.

15.12 Removing the CPU Board

The following tools are necessary to remove this component:
Torx screwdriver T10
Disassemble the external covers as described above, until disassembly of the left
side, to access the component to be replaced. Remove the pumps holder as
explained in the "Pumps disassembly" paragraph.
Before removing the board, make sure that
all wiring harnesses that are connected
with the board have been disconnected.
To remove the CPU board unscrew the 4 screws shown herein.