English
15.2
Removing the coffee grinder
The following tools are necessary to remove this component:
Torx screwdriver T10
Flat-head screwdriver 0.8 x 4 x 80
Long nose pliers
Disassemble the external covers as described above, until disassembly of the upper
cover, to access the component to be replaced.
Disconnect the coffee grinder wiring. Remove the 2 screws shown in figure using a
Torx T10 screwdriver.
Remove the grommet from the grinder adjuster lever.
Remove the grinder adjust. lever.
82
Using long nose pliers, remove the coffee grinder from its support grommets.
Remove the coffee grinder.
Grinder disassemb. and replacement
Turn the ring nut counter-clockwise to align the two arrows as shown in figure.