Rinse/Self-Cleaning Cycle; Energy Saving Mode; Dispensing Beverages Coffee Only; Dispensing Beverages With Milk - Saeco MAGIC M2 Technical Manual

9.3

Rinse/Self-Cleaning Cycle

The cycle permits the internal circuits to be rinsed with fresh water. The cycle is
carried out:
For the coffee circuit
• When the machine is started;
• During the Stand-by preparation phase if coffee was dispensed when the power is
turned on;
• After waking up from stand-by;
For the milk circuit (*only versions M).
• When the machine is started if milk was dispensed when it was turned on previously;
• When waking up after stand-by if at least one milk product was dispensed before
going into stand-by;
• After a specific period of time following the last milk product;
A small amount of water will be dispensed to rinse and heat all the machine parts.
Wait for this cycle to be completed automatically.
9.4

Energy Saving mode

The machine can be set to energy saving mode. If set to energy saving mode, after a
certain period of inactivity since the last delivery, the machine turns off
automatically. This period of time is set by the operator in the programming menu.
During the turn-off phase, the machine will
perform a rinse cycle if a coffee product
has been brewed.
Time can be programmed according to
your needs (see instructions in chapter
"Programming Menu").
To restart the machine simply tap the control panel; the machine will rinse the
coffee circuit; the machine will also rinse the milk circuit if at least one milk product
was dispensed before going into stand-by;
9.5

Dispensing beverages coffee only

Insert the cup or glass under the dispenser.
To dispense a coffee beverage touch the icon of the coffee beverage desired. If the
coffee beverages are not visible on the beverage selection screen, tap the
"COFFEE" icon on the left of the beverage selection screen in the control column
and subsequently tap the icon of the coffee beverage desired.
Start the dispensing cycle. Once the prebrewing cycle has been completed, coffee
begins to come out of the dispensing spout. Coffee brewing stops automatically
when the preset level is reached. it is in any case possible to interrupt the
dispensing by tapping the "STOP" icon.
9.6

Dispensing beverages with milk

(*only versions M).
To correctly use and achieve an optimal
result of the milk product in cup the
silicone suction hose supplied must be
used including the metal reducer located
at its end.
Do not tamper with the hose by modifying
the length and removing the metal reducer
located at its end.
Clean the suction hose externally with a
damp cloth. This way, all parts will be
perfectly clean and free of any milk
residue.
To dispense beverages with milk, the
cappuccino maker must be installed in the
machine.
To ensure better results when preparing
milk, use cold milk.
English
49