Turbine Disassembly; Pumps Disassembly - Saeco MAGIC M2 Technical Manual

15.4

Turbine Disassembly

The following tools are necessary to remove this component:
Torx screwdriver T10
To access the part to be replaced, the external covers explained previously must be
disassembled until the rear panel disassembly.
Pull out the turbine by lifting it upwards.
Disconnect the electrical connection.
Disconnect hydraulic connections.
If disassembly is meant for replacement it is not necessary to open the turbine.
Opening the turbine
Rotate the upper part of the turbine to open the turbine for cleaning operations.
Clean the rotating part of the turbine.
15.5

Pumps disassembly

The following tools are necessary to remove this component:
Torx screwdriver T10
Flat-head screwdriver 0.8 x 4 x 80
Pliers for Oetiker clamps (or pair of tongs)
Disassemble the external covers as described above, until disassembly of the left
side, to access the component to be replaced.
Remove the 3 screws shown in figure using a Torx T10 screwdriver.
English
89