Programming Menu; Accessing The Programming Menus; Button Description In Programming Mode - Saeco MAGIC M2 Technical Manual

English
8

PROGRAMMING MENU

This chapter contains instructions on how
to set and change the programming
parameters of the appliance.
Therefore it is necessary to carefully read it
and to understand the exact sequence of
operations before performing them.
All the operations described in this chapter
must be performed exclusively by the
service provider or a specialised technician,
who shall organise all the operating steps
and use only suitable means to ensure
strict compliance
regulations in force.
The specialised technician or the service provider can change some of the machine
operating parameters to suit the needs of the users.
Notes on programming
The electronic control unit of the appliance allows many functions to be used. A
brief explanation of these main functions is listed below. They are useful for better
managing the appliance's operation but are not necessarily in the same order as
they are displayed in the menu.
Some functions that are specific to certain functional units may be listed; functional
units that differ according to the model.
The layout of the icons/screens in this manual is indicative only and may vary from
those displayed on the appliance, depending on the settings (layouts, themes,
and/or icons).
8.1

Accessing the programming menus

Access the programming menus as follows:
with the door of the service area close, tap the "settings" icon;
or
Remove the drip tray.
36
with the safety
Remove the screw preventing accidental opening of the service compartment flap.
(* 120V USA version only).
Open the service compartment door.
Access the menus by opening the door
only if it is not possible to enter normally
from the tablet.
Depending on the settings, a password may be required to access the programming
menus. Enter the password to access the enabled menus.
There are 2 levels of access to the programming menus depending on the rank of
the operator. The possible levels are:
• User
• Technician
The first screen after access to the programming menu is divided as follows:
• Controls Bar
• Information Area
• Message Area
• Faults Area
• Maintenance Information Area
Controls Bar
Displays the icons of the available controls.
Information Area
Displays information regarding the appliance (software version, etc.).
Message Area
Displays messages of an informative nature, e.g. statistics on the most requested
selections, etc.
Faults Area
Displays the faults found on the appliance.
Maintenance Information Area
Displays information regarding the maintenance deadlines. Maintenance notification
sets the current date/time as the last date of maintenance.
8.2

Button Description in Programming Mode

Menu
Tap the "menu" icon to view the appliance's menu functions. All the functions are
displayed and only those for the profile of the current operator are enabled. Some
of the functions and/or parameters may not be displayed: simply scroll through the
screen.
Exit
Tap the "exit" icon to get out of the programming menus. The selections page will
be displayed.