Adjusting The "Aroma" - Amount Of Ground Coffee - Saeco MAGIC M2 Technical Manual

Remove the screw preventing accidental opening of the service compartment flap.
(* 120V USA version only).
Open the service compartment door and turn the lever by only one notch.
Close the door again and brew 1-2 cups of coffee to verify the changes in the
grinding degree. Repeat the procedure until you reach the desired grind setting.
Re-insert the screw preventing accidental opening of the service compartment flap.
(* 120V USA version only).
The reference marks indicate the grind setting. There are different grind settings to
choose from with the following references:
1 - Fine grind
2 - Coarse grind
7.9

Adjusting the "Aroma" - Amount of Ground Coffee

The machine makes it possible to regulate the quantity of coffee being ground for
the preparation of every single coffee-based beverage. The regulation must be done
by accessing to programming menu of the machine. Modifying the quantity of coffee
ground in the recipes of the beverages. The reference marks indicate the amount of
ground coffee which has been set.
Different quantities of ground coffee can be set for every recipe with the following
references:
1 - Minimum coffee quantity
4 - Maximum coffee quantity
The amount of coffee that is ground can be further adjusted via the Aroma
adjustment lever.
This operation may only be carried out by
specialised technical personnel.
The Aroma adjusting lever must only be
turned when the coffee grinder is stopped.
The adjustment
before brewing coffee.
DO NOT change the coffee dose if the
pre-grinding option is active (set on "ON").
must be performed
The adjustment can be done using the lever located on the side in the service
compartment of the machine. Remove the drip tray.
Remove the screw preventing accidental opening of the service compartment flap.
(* 120V USA version only).
Open the service compartment door.
The reference marks indicate the amount of ground coffee which has been set.
A - Minimum coffee quantity
B - Maximum coffee quantity
The following figure shows the default setting of the position of the adjusting lever.
English
33