Programming And Maintenance Menu; Description Of Buttons For Programming Phases; Programming Menu - Saeco IDEA RST Technical Manual

8

PROGRAMMING AND MAINTENANCE MENU

This chapter contains instructions on how
to set and change the programming
parameters of the appliance.
Therefore it is necessary to carefully read it
and to understand the exact sequence of
operations before performing them.
8.1

Description of Buttons for Programming Phases

Use the buttons described below to scroll the appliance menus.
During programming the following buttons
have a different function than the one they
usually have during machine use.
Some functions also enable to program one or more data (already
programmed on standard values).
BUTTON Description
Go back to the previous option inside the same programming
1 Up
level;
Increase the value of a datum to be changed.
Go on to the following option inside the same programming
2 Down
level;
Decrease the value of the datum to be changed.
Move from a menu level to another one;
3 OK
Prepare a datum for the change;
Confirm a datum or a function.
Enter the programming menu;
4 Menu/Esc
Confirm the changes and go back to the previous menu level
until exiting the menu.
To adjust the data values to be re-programmed:
• Select the function.
• Confirm the function with the "OK" button.
The cursor moves under the value to be changed.
• Press the "Up" or "Down" buttons to change its value.
• Confirm the modified datum with the "OK" or "Esc" button.
FUNCTION
8.2

Programming Menu

The structure of the programming menu is indicated in section
"Structure of the Programming Menu".
The section "Description of Messages in the Programming Menu"
describes all the items in the programming menu.
8.2.1 Access to the Programming Menu
Press the button shown in the figure to enter the programming menu
Enter the Password by pressing the UP or DOWN buttons to select a number.
Press OK to confirm and move on to the following box.
Press ESC to confirm and exit.
Once the password has been entered, it remains active for 5 minutes after exiting the menu.
If you switch off the machine, it will be necessary to enter the password again in case you want to enter
the menu.
After entering the password the display will show the following options:
GENERAL SETTING
Beverage set-up
Maintenance
Technical
Washing Menu
MILK PROGRAMMING
Test menu
The "Technical" and "Test Menu" menus can only be accessed by the maintenance
technician by entering the password.
If you forget your access password, please
contact the manufacturing company. By
providing the company with the machine
serial number, you will be given the PUK
code.
If the CPU board has been replaced, the
access password will be as follows: 1234
English
21