Flush Mounting Procedure - Raytheon ST60 Owner's Handbook Manual

20
3. Referring to the Fitting the low-profile bezel illustration, place the
4. Snap the low-profile bezel (8) in position over the instrument, so
CAUTION:
It is essential that only screws of the correct size are used to secure
the instrument to the bezel. Failure to observe this caution could
result in damage to both the instrument and the bezel.
5. Using the four, self-tapping screws (9) provided, secure the

Flush mounting procedure

Flush mounting procedure Flush mounting procedure Flush mounting procedure Flush mounting procedure
Flush mount your instrument ( see the Flush mounting illustration) as
follows:
1. Assemble the ST60 instrument and low-profile bezel as described
instrument face upwards on a flat surface and place the rubber
keypad (7) in position around the display window (i.e. so that each
key outline is located over its associated key on the instrument).
that the rubber keys are correctly located in the holes on the bezel.
instrument and bezel together. Fit the screws from the rear of the
instrument and tighten them sufficiently to secure the instrument
and bezel together. DO NOT OVERTIGHTEN.
Fitting the low profile bezel
under Fitting the low-profile bezel.
ST60 Tridata Instrument Owner's Handbook
8 7 9
D4362-1