Unpacking; Fitting The Instrument; Surface Mounting - Raytheon ST60 Owner's Handbook Manual

18

Unpacking

Unpack your ST60 equipment and check that the items described in
Introduction are present.
Each ST60 instrument is supplied with a standard bezel for surface
mounting. Optional mounting kits are available for flush mounting and
bracket mounting the instrument. If you have ordered the flush
mounting option a low-profile bezel and four fixing screws are also
provided.

Fitting the instrument

The ST60 Tridata instrument can be installed using one of a number of
different mounting options:
• Surface mounting. Gives a profile of approximately 24 mm.
• Flush mounting. Gives a profile of approximately 6 mm.
• Bracket mounting.
The ST60 instruments can also be mounted behind a panel with just
the instrument dial and keys visible.

Surface mounting

To surface mount your ST60 instrument (see the Surface mounting
illustration):
1. Ensure that:
2. Apply the surface mount template (supplied at the rear of this
3. Drill out the two 5 mm fixing stud clearance holes (2).
4. Cut out the clearance hole (3) then remove the template.
5. Peel off the protective sheet from the self-adhesive gasket (4) then
6. Screw the two fixing studs into the threaded sockets on the rear of
7. Mount the assembled instrument, studs, bezel and gasket into the
• The selected location is clean, smooth and flat.
• There is sufficient space behind the location to accommodate
the rear of the instrument and connectors.
handbook) to the selected location and mark the centres for the
fixing studs (1) and the aperture (3) that will take the rear casing of
the instrument.
stick the gasket into position on the rear of the instrument.
the instrument.
panel. Secure from behind with the thumb nuts (5).
ST60 Tridata Instrument Owner's Handbook