Flush Mounting; Fitting The Low-Profile Bezel - Raytheon ST60 Owner's Handbook Manual

Chapter 3: Installation

Flush mounting

The Flush Mounting Kit uses a low-profile bezel to reduce the fitted
profile of the instrument, to approximately 6 mm above the panel
fascia.

Fitting the low-profile bezel

Fitting the low-profile bezel
Fitting the low-profile bezel Fitting the low-profile bezel Fitting the low-profile bezel
In order to flush-mount your ST60 instrument, you must first replace
the standard bezel with the low-profile bezel as follows:
1. Hold the instrument in both hands with the display towards you.
2. Using both thumbs, gently press an upper corner of the instrument
Surface mounting
from the bezel, then remove the bezel from the instrument. Retain
the rubber keypad which is released when the bezel is removed.
4 1 2 1 3 5
D4537-1
19
2 5
D4343-1