Boat Show Mode; Factory Defaults; Leaving Dealer Calibration - Raytheon ST60 Owner's Handbook Manual

Chapter 4: Calibration

Boat show mode

CAUTION:
Do NOT enable this mode. It must only be used for demonstration
purposes.
Ensure that the Boatshow Mode Use is set to OFF. If necessary, use the
trip trip trip or reset
trip trip

Factory defaults

You can use this screen to reset the operating parameters to the factory
default values. If you want to apply the factory defaults, ensure the
display shows YES, but if you want to retain the values you have set up,
ensure that the display shows NO. Use the trip
make the required selection.
The values you have selected will be applied when you exit this screen.

Leaving Dealer calibration

Hold down the depth and speed keys for 2 seconds to save your
settings, exit Dealer calibration and resume normal operation.
reset reset key to achieve this. reset
reset
trip trip reset reset
trip and reset trip reset keys to reset
41