Stand Alone Instruments - Raytheon ST60 Owner's Handbook Manual

Chapter 3: Installation

Stand alone instruments

Stand alone instruments Stand alone instruments
Stand alone instruments Stand alone instruments
Stand-alone instruments are not connected to SeaTalk and therefore
need to be connected to an alternative 12 V power source. Power
cables are available in 2 m and 9 m lengths.
1. Run the cable from the instrument to a suitable 12 V dc power
2. If the cable has not already been trimmed at the power supply end:
3. Connect the screen to the power supply 0 V terminal.
4. Connect the red wire via a 3 A over-current circuit breaker to the
Red
5 A fused,
12 V dc supply
(typically provided
by autopilot)
Screen
Red
Screen
SeaTalk power connections
To fit a power cable:
source.
a. Cut the cable to length and trim back an appropriate amount
of the outer sheath.
b. Cut back and insulate the yellow wire.
3 A over-current
12 V dc
supply
Power connections for stand-alone instrument
power supply +12 V terminal.
1 2
20 19
circuit breaker
Red
Screen
3 4
Instruments
5 to 16
18 17
D4311-1
D4310-1
25