Flush Mounting Procedure - Raytheon ST60 Owner's Handbook Manual

18
4. Snap the low-profile bezel (8) in position over the instrument, so
CAUTION:
It is essential that only screws of the correct size are used to secure
the instrument to the bezel. Failure to observe this caution could
result in damage to both the instrument and the bezel.
5. Using the four, self-tapping screws (9) provided, secure the

Flush mounting procedure

Flush mount your instrument (see the Flush mounting illustration) as
follows:
1. Assemble the ST60 instrument and low-profile bezel as described
2. Ensure that:
Fitting the low-profile bezel
that the rubber keys are correctly located in the holes on the bezel.
instrument and bezel together. Fit the screws from the rear of the
instrument and tighten them sufficiently to secure the instrument
and bezel together. DO NOT OVERTIGHTEN.
under Fitting the low-profile bezel.
• The panel on which you intend to mount the instrument is
between 3 mm and 20 mm thickness.
ST60 Multi Instrument Owner's Handbook
8 7 9
D4361-1