Leaving Intermediate Calibration; Dealer Calibration; User Calibration On/Off; Response Settings - Raytheon ST60 Owner's Handbook Manual

Chapter 4: Calibration

Leaving Intermediate calibration

Hold down the depth and speed keys for 2 seconds, to save your
settings, exit Intermediate calibration and resume normal operation.

4.4 Dealer calibration

The Dealer calibration procedures enable the following parameters to
be set:

• User calibration on/off.

• Speed response.
• Depth response.
• Boat show mode on/off.
Dealer calibration also gives access to the Factory defaults screen. This
enables you to re-apply the factory settings if you want to reset the
instrument to a known operating condition.
To commence Dealer calibration, hold down the depth and speed
keys together for approximately 12 seconds, to select the Dealer
calibration entry page (see Dealer calibration diagram). Then press the
trip and reset keys together, to enter the calibration screen sequence.
Use the depth key to move from screen to screen and the trip or the
rest key to set the required values at each screen.
User calibration on/off
Press either the trip or reset key to toggle the User calibration on or
off as required. With off selected, User calibration and Intermediate
calibration are both disabled.

Response settings

The response values for both SPEED and DEPTH determine the
frequency at which information is updated. A low number provides a
smooth response and a high number a much livelier update.
Use the trip
required value. Response values are from 1 to 15.
trip trip
trip (decrement) and reset trip
reset reset
reset (increment) keys to set the reset
39