Chapter 3: Installation; Planning Your Installation; Site Requirements; Transducers - Raytheon ST60 Owner's Handbook Manual

Chapter 3: Installation

Chapter 3: Installation
This chapter describes how to install the ST60 Tridata instrument, and
associated speed and depth transducers. The transducers are fitted in
the hull of the vessel and connected to the rear of the instrument. The
actual type of transducers depends on the type of hull in which they are
to be installed.
For advice, or further information regarding the installation of this
equipment, please contact the Raytheon Product Support Department
or your own National Distributor.

3.1 Planning your installation

Before starting the installation, spend some time considering the best
positions for both transducer and instrument, such that the Site
Requirements and the EMC Guidelines (below) are satisfied.

Site requirements

Transducers

Transducers Transducers
Transducers Transducers
The transducer types required for the various hull types are as follows:
75mm (2.94in)
diameter
Depth
51mm (2.0in)
diameter
75mm (2.94in)
diameter (0.19in)
Transducer dimensions
Speed
5mm
75mm (2.94in)
diameter
51mm (2.0in) 14mm
diameter (0.57in)
75mm (2.94in)
diameter
13
D4447-1