Flush Mounting; Fitting The Low-Profile Bezel - Raytheon ST60 Owner's Handbook Manual

Chapter 3: Installation
2. Apply the surface mount template (supplied at the rear of this
3. Drill out the two 5 mm fixing stud clearance holes (2).
4. Cut out the clearance hole (3) then remove the template.
5. Peel off the protective sheet from the self-adhesive gasket (4) then
6. Screw the two fixing studs into the threaded sockets on the rear of
7. Mount the assembled instrument, studs, bezel and gasket into the

Flush mounting

The Flush Mounting Kit uses a low-profile bezel to reduce the fitted
profile of the instrument, to approximately 6 mm above the panel
fascia.

Fitting the low-profile bezel

In order to flush-mount your ST60 instrument, you must first replace
the standard bezel with the low-profile bezel as follows:
1. Hold the instrument in both hands with the display towards you.
2. Using both thumbs, gently press an upper corner of the instrument
3. Referring to the Fitting low-profile bezel illustration, place the
handbook) to the selected location and mark the centres for the
fixing studs (1) and the aperture (3) that will take the rear casing of
the instrument.
stick the gasket into position on the rear of the instrument.
the instrument.
panel. Secure from behind with the thumb nuts (5).
from the bezel, then remove the bezel from the instrument. Retain
the rubber keypad which is released when the bezel is removed.
instrument face upwards on a flat surface and place the rubber
keypad (7) in position around the display window (i.e. so that each
key outline is located over its associated key on the instrument).
D4537-1
17