Flush Mounting; Fitting The Low-Profile Bezel - Raytheon ST60 Owner's Handbook Manual

12

Flush Mounting

The Flush Mounting Kit uses a low-profile bezel to reduce the fitted
profile of the instrument, to approximately 6 mm above the panel
fascia.

Fitting the low-profile bezel

In order to flush-mount your ST60 instrument, you must first replace
the standard bezel with the low-profile bezel as follows:
1. Hold the instrument in both hands with the display towards you.
2. Using both thumbs, gently press an upper corner of the instrument
3. Place the instrument face upwards on a flat surface and place the
4. Snap the low-profile bezel (8) in position over the instrument, so
CAUTION:
It is essential that only screws of the correct size are used to secure
the instrument to the bezel. Failure to observe this caution could
result in damage to both the instrument and the bezel.
5. Using the four, self-tapping screws (9) provided, secure the
from the bezel, then remove the bezel from the instrument. Retain
the rubber keypad which is released when the bezel is removed.
rubber keypad (7) in position around the display window (i.e. so
that each key outline is located over its associated key on the
instrument).
that the rubber keys are correctly located in the holes on the bezel.
instrument and bezel together. Fit the screws from the rear of the
instrument and tighten them sufficiently to secure the instrument
and bezel together. DO NOT OVERTIGHTEN.
ST60 Club House Wind Instrument Owner's Handbook
D4537-1