Command access MLRK1 Insert Instructions page 5

Remove roll pin from back of connecting rod by
6.
detaching "C" clip from either side.(A) Remove pin
completely. (B)
7. Remove roll pin from kit (C) and line up holes with
device holes. (D)
8. Push roll pin through kit and device holes and
attach "C" clips. (E) Once attached, motor
should be secure. (F)
Once the kit is secure with the pin, lift up and insert
9.
back screw into the bottom dogging hole. Do not
tighten until device is assembled.
10.
Once kit is connected, flip device over and put
screws back in dogging holes.
C o m m a n d A c c e s s T e c h n o l o g i e s | 2 2 9 0 1 L a P a l m a A v e , Y o r b a L i n d a , C A 9 2 8 8 7 | P h o n e : ( 8 8 8 ) 6 2 2 - 2 3 7 7
Command Access is not a licensee, or affiliated, associated or connected with Allegion, Assa Abloy, Stanley, Schlage, Falcon, Von Duprin, Dorma, Sargent, Corbin Russwin, Yale, Emtek, Adams Rite, Best, Precision, Arrow,
Design Hardware, Cal Royal, Jackson, AHT, Marshall Best, Marks, Accurate, Baldwin, FSB, PDQ, Lawrence, Trans Atlantic, Hager, LSDA, General Lock, or Omnia or any of their subsidiaries or affiliates.
Installation Instructions
A
C
E
B
D
F