aerauliqa QR280E Instructions For Installation, Use And Maintenance Manual page 46

User Menu
1 Mode Selection
2 Boost
3 Boost Duration
4 Reset FILTER Alarm
5 Night Mode
6 Weekly timer
7 Installer Menu
User Menu
1 Mode Selection
2 Boost
3 Boost Duration
4 Reset FILTER Alarm
5 Night Mode
6 Weekly timer
7 Installer Menu
7.2 Installer Menu on CTRL-DSP
The Installer menu can be selected either by selecting point 7 in the User Menu or by pressing OK+ESC for about 7 seconds. To
exit the Installer Menu press ESC or wait for about 60 seconds.
Installer Menu
1 Language
2 Date/time
3 Machine orientation
4 Normal Mode
6 Bypass settings
8 Heating
10 Speed setting
11 Airflow Balancing
12 F7 filter
13 Filter Alarm interval
15 Constant Pressure
17 Periodic purge
18 Working Hours Counter
19 ModBus settings
20 Save settings
21 Load Settings
22 Restore Default Settings
23 Contrast
24 Backlight
25 Debug page
46
It allows to set the time slots and the operating speeds throughout the week when the unit is
set to Normal Mode 3V.
Press OK to select.
Choose NO or YES using  or .
Press OK to select.
Factory setting (DEFAULT): NO.
If "YES" is chosen, pressing OK the Monday time program is displayed.
Change the days using  or .
Press OK to set the daily time program (max 4 time slots).
Switch from hours-minutes-speeds using  or .
Change hours-minutes-speeds using  or .
The daily program can be copied in the following days pressing OK.
Save the setting pressing ESC and then OK.
If the Weekly Timer is activated, the icon
Note: in the intervals not included in the programmed time slots the unit is OFF. The icon
.m...is displayed.
In case both the Weekly Timer and the Night Mode need to be used, make reference to the
User Menu "5 Night Mode" for more details.
In case both the Weekly Timer and the Boost functionality need to be used, make reference to
the User Menu "2 Boost" for more details.
It allows to select the Installer menu.
Enter
installer menu?
Press OK to enter the Installer menu.
Press ESC to go back to the previous menu.
Select the menu item using  or .
is displayed.